How To Use Your BlendJet Portable Blender - BlendJet 2 Tips and Tricks

Hi blend Ters .

Thank you for your purchase with us .

This video will help you become a blend jet master and we will answer any questions you might have .

Let's blend away first use .

Charge your blend jet with the included USB cable for about one hour or until the light ring shows a solid blue circle .

Ensure the arrows on the rear of the jar and base are closely aligned .

Clean your blend out prior to first use , add water , a drop of soap blend and rinse add liquid first then throw in your solids , leave a little room at the top , tighten the lid and press the power button to blend for one 22nd cycle .

Repeat as needed for thicker blends .

Enjoy your blended creation and clean .

Immediately after each use charging using the included USB C cable , you can charge your blend jet with most USB ports from your phone charger to your computer to the USB port in your car .

Your blend jet takes about 1.5 hours to fully charge and lasts for 15 plus blends .

The light ring on the power button indicates battery level while charging as your blend jet .

Charges , the lights will change from purple to blue when the light around the power button forms a complete blue circle , your blend jet is fully charged .

The circle turns purple instead of blue while blending or pulsing .

Whenever the battery is getting low , the circle will flash red and purple when the battery is dead and it's time to recharge pulse mode to enter pulse mode .

Double press the power button .

Blue lights will flash left to right three times and the swirl will stay illuminated while pulse mode is active and hold the power button repeatedly to pulse .

Pulse mode will automatically end after five seconds of inactivity lock mode , hold down the power button for three seconds .

The purple circle will flash three times to indicate lock mode is active to unlock .

Hold down the power button for three seconds until the purple lights disappear .

A blue circle will flash three times indicating your blend jet is unlocked and ready to blend again .

Flashing red light loosen the jar from the base and screw it back in until the arrows on the back of the jar and base line up .

The best way to tell when the jar is properly aligned .

We'll be looking at the power button on the front when it flashes white instead of red .

That means you're good to go .

Solid red light blades are blocked , flip your blend jet upside down and give it a shake to loosen the jam .

Start blending upside down , then turn it right side up again .

So your ingredients hit the blades at full speed .

Basic cleaning , fill the jar about two thirds full with warm not hot water .

Add a drop of dish soap and blend for one full cycle until your blend jet automatically stops .

Pour out liquid and rinse with clean water .

Deep cleaning as needed .

Remove the jar from the base , twist the jar counter clockwise while twisting the base in the opposite direction .

Using a fork , carefully , remove the silicone gaskets from the lid and base for a more thorough clean wash the jar lid and gaskets in soapy water .

Use a dish brush to dislodge any debris around the blades if needed .

Never put your hands in the path of the blades .

Each part should be left out long enough to fully air dry , to reassemble your blend .

Place the grooved gasket back in the base , make sure the grooved side is facing down .

Next place the jar on top and screw it into the base to push in the gasket fully place the second gasket back in the lid .

We hope this answers all your questions .

Please feel free to reach out to us if you need help with anything else and follow us on social media for recipes and more .