How to Troubleshoot a Fan Remote _ The Home Depot

A remote makes it easier to operate a ceiling fan .

But if it isn't working , this video will help you get it back in motion .

Here's what you'll need .

Make sure the wall switch is in the on position .

If the wall switch doesn't turn on the fan , check the circuit breaker , a ceiling fan remote contains a transmitter that when working properly sends a signal to a receiver in the ceiling fan to test the remote , try using it within 10 to 20 ft of the fan .

If it only works in a very close range , the batteries may need to be replaced .

If the remote has an indicator and it doesn't light up , you will likely need to replace the batteries check to make sure they are in the correct position and use a battery tester to confirm if they need to be replaced .

Ceiling fans have a dip switch frequency which can be reset , start by turning off the power to the fan at the circuit breaker .

Use a screwdriver to detach the fan canopy , locate the dip switch on the receiver , then use a small screwdriver or a ballpoint pen to create a new frequency and record the new dip switch setting , return the receiver to the ceiling fan and reattach the canopy , then turn the power back on at the circuit breaker .

The next step is setting the frequency of the remote , remove the batteries of the remote in the small panel that covers the dip switch , use a pen or a screwdriver to slide the buttons to match the frequency of the fan .

Replace the batteries , put the remote back together and check to see if it operates the fan .

If the remote is still not working , it's time to replace it .

Use a universal remote or replacement .

That is the same brand as the ceiling fan .

Adjust the dip switch to match the frequency of the fan and install batteries pair the universal remote by pressing the start up buttons .

According to manufacturers instructions .

Good luck .

And thanks for shopping at the Home Depot .