How to make Paper Flowers Rhododendron (Flower # 44)

Hi .

Today , I'm gonna make rhododendrons .

A beautiful bunch of flowers material required are gray paper and orange , orange , red and green .

A thick wire for the stem , 10 wire for time , green floral tape and I've used white color for the statement .

You can change this color according to the color of the great paper cut stens according to the measurements given all the measurements are in centimeters .

This is of a peter .

This is 2.25 centimeter by five centimeter long and got five pieces per floor and you make 8 to 10 flowers per bunch .

This is a stencil of a statement .

This is 4.5 centimeters by one centimeter cut one piece per floor .

This is of two leaves , two sizes .

One is 11 centimeter by 4.5 centimeter and one centimeter stem .

This is 3.5 centimeter wide by nine centimeter and one centimeter stem .

Again , cut five or six big and small leaves for a bunch of flowers .

Now take the strip for steam and cut very thin strips on it .

I leave about uh half a centimeter gap .

Here I apply glue on the base and roll this up .

Now take some white paint and dab it on top of the statement .

Now take a pet , first call the upper portion and then with the scissors only score it along the center a deep score and then just give the crims on the edges all along the edges .

So you get petals like this , apply glue on the edge of the petal just along the edge , a little blue and stick another petal on it slightly at an angle .

I and similarly stick all the other petals after sticking like this , let it dry completely .

After the petals have dried , they were really copping on all the stems of all the petros .

So just hold very firmly the edges so that they don't come apart and then cut it , apply glue on the side and stick this on the other side to create a funnel shape .

I know .

Now insert the statement that we've made earlier and then tie the flower at the base , just collect the edges together and tie it up .

I can give a twist shape , the floor using a thick wire , just push out the paper so that it forms a clean shape ship and then open out the petals .

You get far like this .

Now cut out a piece of green tape stretched and then wind this around the base of the floor till the end of the bio I know and this is how it will look .

Now collect all the flowers together , make a bunch of them , make a bunch like this .

Put a thick wire and then tie this tightly with a thin wire .

Now take a leaf and score on it with scissors make veins on that because the veins on the leaves of rhododendron are pretty well defined .

So just do this .

Now apply uh tie the green tape on the floor bunch starting on the base and then put the leaves all around it in a circular form .

Know and this is how the finished flower would look .