How to make Paper flowers Daffodils _ Narcissus (Flower # 7)

Hi .

Today we learn how to make daffodils for this .

You need green color , faulty , a thin flexible wire , a thick straight wire , yellow color gray paper , green color gray paper , six yellow colored tips , scissors , pencil and blue .

You need to cut out stencils for this which are all measured in centimeters .

The first stencils of a corona which is cut out in one piece .

The second stance is of a petal which is cut out in six pieces .

The third stens is of a BRACT which is cut out in one piece and the fourth stencil of a leaf which is cut out in two pieces .

Now you take the pips and you cut off one end of them using a pair of scissors .

You place one of the pips a bit higher , one centimeter higher than the rest of the pips .

And you tie it around the thick straight wire on top of the thick straight wire using a thin flexible wire .

Now you take two inches of soil tape and you wind it from the base of the pips till the wire .

Now you take the corona and fold it into half and using a pair of scissors , you call one of its side like this and it will look like this .

Now , using the nail of both your thumb and your index finger , you pull the paper in opposite direction .

This is called crimping .

You do it on the side of the paper .

Now you apply glue on one side of the paper and then you stick the other side on top of it , making a circle .

Does how it look like .

You place your thumb inside the corona and you push the paper outward , giving it a cup effect .

It look like this .

Now you pass it through the thick straight wire and you tie its base using a thin flexible wire .

Now you take a petty and you fold it a little more than half and then you fold it back again , forming a pleat .

Now using your index finger nails , you form ridges by pushing the paper outward from the back side of the pedal .

In both the sides , you do the same but in opposite direction towards the edges on both the sides .

And this is how it look like .

Now you take two flexible wires of 10 inches of length .

Approximately , you twist one of its end , you take one of the petal and you place it in between the wires and you push it in forming creases and then you twist the other side two centimeters of the other side , you do the same for the other petals after you've put all the petals , it look like this .

Now , you need to wind the petals around the floor .

It looked like this .

Now you wind the extra bit of the wire around the six straight wire .

You apply a bit of glue on the base of the and you stick a bit of soil , tape around the base till the wire after you stuck the tape and look like this .

Now , you need to open the petals and using a pair of plyo , you bend the flower from the base itself and it will look like this .

Now you take the piece of brack and leaving a gap of three centimeter from the bend portion .

You stick it .

Sorry , you tired using the thin flexible wire .

Thanks it , look like this .

Now you wind the tape from the base of the brack till 18 centimeters of the wire .

You put a bit of glue and then you stick the tape .

Now you take both the leaves and you place them around the base of the tape and you tied it inflexible wire around it .

Now you take the floor tape and you tie it from the base of the leaves till the end of the wire .

And here's a daffodil .

Thanks for watching our video .