I'd like to show you some tips so you can make a nice ball .
First of all , with the right end of ribbon , make one loop and the tear you would like to make , then release it , pull this point and put on where you direct to make a ball take the right shorter in toward the upper , take the longer end ribbon around them and wrap under the box to the front at the point where I like to make a ball , turn it corner to the left , using the longer end , pull around it by some , make sure the back is flat .
Then up to the front , the longer end should be on the knees of the shorter end .
The right shoulder end goes over and through and the cross point then put it out , pointing in the upper right hand corner .
This is the most important tip .
If you keep this rule , your ball would be always straight , tie it .
Family make a loop with the longer end toward the upper right with a shooter end , make it go up and over the loop , then push into this hole and put it out through to the left side , pull the both loops to tighten the knot for tightening it pull out the upper side of the left loop and the bottom side of the right loop , adjust the about and trim the the desired cutting ribbon .
Always at the end four loops bow , it's same , make one loop and the tail with the right short end of the ribbon .
This time , let's make it just wrap around horizontally but not cross .
The longer end should be under the knees of the shorter end where the right shoulder end goes over and through and the longer end at the point then put it out , pointing in the upper right hand corner as the same rule .
After you make the first loop with the longer and continue to make another loop on the left side and another one on the right side .
Now we have two loops on the right side and one loop on the left side , get the other loops in the center then with the right and make it go over and push into the hole and pull out to the left .
You can make any number of loops just keep right side , always one more loop than the left side .
Put the upper side of the bottom loop on the left and the lower side of the bottom loop on the right to tighten , adjustable nicely , then trim the tails as desired .
Practice with smile makes perfect .